home *** CD-ROM | disk | FTP | other *** search
/ Amiga Collections: Topik / Topik - Disk 04 - Disk and Technical Stuff (19xx)(Topik Public Domain)(PD)[WB].zip / Topik - Disk 04 - Disk and Technical Stuff (19xx)(Topik Public Domain)(PD)[WB].adf / Electronix / 1.3Change500 < prev    next >
Text File  |  1989-06-21  |  2KB  |  67 lines

  1.  
  2.  
  3.  
  4.  
  5.  
  6.  
  7.  
  8.  Amiga 500 KickStart 1.3 ROM Replacement
  9.  ---------------------------------------
  10.  
  11.  
  12.  
  13.  
  14.  - Remove the cover of the 500, there are three TORX  screws in the front
  15.    and three in the back.
  16.  
  17.  
  18.  - Unplug the keyboard, by gently pulling the connector going into the metal
  19.    straight up. NOTE which way the connector goes, there is a black wire
  20.    on the left side. This must be put back on correctly, or damage will
  21.    result to the keyboard and/or computer.
  22.  
  23.  
  24.  - Move the keyboard out of the way, and remove the metal sheild. There
  25.    are four metal tabs that have to be bent up, and four TORX screws in
  26.    the sheild (two in the front, and two in the left side).
  27.  
  28.  
  29.  - Locate the KickStart ROM (see enclosed figure), it has the part
  30.    number 315093. The dash and last two numbers indicate which version.
  31.    KickStart 1.2 is version 01, and KickStart 1.3 is version 02.
  32.  
  33.  
  34.  - Notice the direction of the chip. It has a notch in one end. The
  35.    replacement chip MUST go in the same way. Gently pry the old chip out
  36.    with a small flat object wedged between the chip, and the socket. Work
  37.    at both end, a little bit at a time.
  38.  
  39.  
  40.  - Set one side of pins, of the new ROM into the socket. Using two fingers,
  41.    GENTLY push on the free end, until it will go into the socket. Then after
  42.    you are CERTAIN, both sides of the chip are in the socket, push down on
  43.    the chip, to seat it all the way into the socket.
  44.  
  45.  
  46.  - Reassemble the system, and power it up. You should immeadiately see the
  47.    screen change through it's startup colors and give you the WorkBench
  48.    prompt with a little V1.3 in the corner. If you do not, immeadiately turn
  49.    off the computer and double check everything. If you did, congratulations
  50.    on your success!
  51.  
  52.  
  53.  
  54.  
  55.  
  56.  
  57.  
  58.  
  59.  
  60.  
  61.  
  62.  
  63.  
  64.  
  65.  
  66.  
  67.